The board works just like a USB camera, but requires specific software to visualize the data such as GetThermal open-source image viewer for Linux and macOS. PureThermal 3 board with Tag-Connect EC-10-IDC Misc – Boot and Reset buttons ( improved).Castellated edge with full JTAG breakout for rapid flashing via Tag-Connect EC-10-IDC.Supports flash custom firmware with USB DFU.I/Os – Partially MikroBUS compatible breakout pin configuration with GPIOs, UART, I2C, SPI (3V), +5V (V_IN), +3.3V (+3V), and GND.USB – USB Type-C port with USB UVC (works on Windows, Linux, Mac, and sometimes Android).Ships with FLIR Lepton FS non-radiometric 160 x 120 resolution micro thermal camera module.Supports LIR Lepton (2.x – 3.x) LWIR camera cores.
Microcontroller – STMicro STM32F412 Arm Cortex-M4 MCU 100 MHz with up to 1024 KB flash, 256 KB SRAM.PureThermal 3 specifications with changes highlighted in bold: Some changes include the removal of pads to install an RF shield, and the Tag-Connect TC2030 programming connector is replaced by the Tag-Connect EC-10-IDC. The company explains the new model offers the same basic functionality as the PureThermal 2 but with a few changes and additional features, although the motivation for the new design was primarily to address component shortages. Groupgets PureThermal 3 (PT3) is a hackable thermal webcam that ships with the low-cost FLIR Lepton FS module, and is compatible with FLIR Lepton (2.x – 3.x) LWIR camera core.
0 kommentar(er)
